Mycroburst.com - Home
English | Français | العربية

877-525-5646

Equipe commerciale: du lundi au samedi, de 13h00 à 17h00 CET
Assistance technique: du lundi au samedi, de 13h00 à 17h00 CET



Démarrez un projet Parcourez les projets

Trade Association Logo

Washington Collectors Association


Comment Réussir un Projet


  • Rapport du projet

Gagné

Modèle #203 Choisi en tant que gagnant

Un logo, monogramme ou une icône | Crée par WashingtonCollectors

  • Gains
    600,00 $ Garanti
  • Créations
    223
  • Fermer
  •  Gagnants
    1
    Plus d’info

Classez les modèles par:

  • Lisez Bref


Discussion

25 Commentaire récents

  • 6 mars 2011 21:59 room171

    i have ide :)

  • 5 mars 2011 14:35 WashingtonCollectors
    Porteur du Projet

    I would like to express my appreciation and thank all of you designers who have submitted designs for this project. You are very gifted and extremely talented individuals. This has been very hard to narrow down all the great designs and choose a winner. One design concept in particular has caught our eye from the very beginning. After careful consideration, we would like to announce that KakoPouli is the project winner. Please do not submit any further designs for us to review on this project. We will continue to work with KakoPouli offline in fine tuning his logo for us. Again, great job everyone on your ideas and submissions, we really appreciate your efforts!

  • 2 mars 2011 16:17 SiteAdmin
    Employé(e)

    Project has been extended for 3 more days.
    James

  • 28 février 2011 14:36 SiteAdmin
    Employé(e)

    Project has been extended for 3 more days.
    James

  • 20 février 2011 02:47 WashingtonCollectors
    Porteur du Projet

    #181- I like this new and different version of the WCA

  • 20 février 2011 01:39 SiteAdmin
    Employé(e)

    Draft #151 and variation by x3mart, and #149 by room171 are derivative of #54 by KakoPouli therefore have been taken down.

  • 19 février 2011 20:00 x3mart

    I will work on the new changes and re upload in a few.
    Regarding the space you asked before, is aldeady on the last 2 upload

  • 19 février 2011 19:04 WashingtonCollectors
    Porteur du Projet

    #157- change color above the mountain to blue inside the state, keep everything else the same.

  • 19 février 2011 18:57 WashingtonCollectors
    Porteur du Projet

    #164- try something. You have an interesting break line between the the W&C. Can you do the same type of break on the horizontal bridge line inside the A? It could maybe be either on the left or right side of the bridge, whichever looks better. Also, have you created the logo previously mentioned whereas you extended the state map more out to the left? I was not sure because after a while all its hard to tell all the slight variations between similar logos. Thanks.

  • 19 février 2011 15:35 x3mart

    #164-165 are the revision on #158.
    Thanks

  • 19 février 2011 14:52 WashingtonCollectors
    Porteur du Projet

    #158- how would this look in B&W? Thanks.

  • 19 février 2011 14:51 WashingtonCollectors
    Porteur du Projet

    Hi Designers. Great work coming in...it just keeps getting better. I have extended the project contest for an additional 3 days so I can fine tune with you some of the great logos here, as well as review anything that happens to drop in at the last minute. Thank you...keep up the great work!

  • 19 février 2011 14:33 WashingtonCollectors
    Porteur du Projet

    x3mart: Wow..nice!! #158-this new logo concept is excellent. I like that that it gives me options of where I can put text around the state map. Mountain looks good. New WCA concept is very modern. Let's tweak something to see how it looks. Using the #158 concept, give me just a tad little more of the state washington on the left side. In other words, show a little more of the the east side of the state...then come in with the WCA. Thanks...great work.

  • 19 février 2011 04:22 WashingtonCollectors
    Porteur du Projet

    Kakapouli- further clarification on #142 from latest suggestion, everything in the WCA that you see the inside white line coming to a point, make that point similar to the mountain peak points from the map.

  • 19 février 2011 04:20 WashingtonCollectors
    Porteur du Projet

    #105- Try this..in the map only, everything above the mountains, make it blue. In the map only, everything below the moutains make it green. Then give me a flip/flop version color of that. Thank you!!

  • 19 février 2011 04:10 WashingtonCollectors
    Porteur du Projet

    #142- Try this; Carrying on with lightning bolt tip theme from previous comments, let's see if this can carry through through the middle lines of the WCA. At certain end point of the WCA, rather than take the white line to the very end, stop it a little short, and put a pointy tip just like the end of point of the mt.caps. It might not even be noticeable, but give it a try. Thank you.

  • 19 février 2011 03:49 WashingtonCollectors
    Porteur du Projet

    #143- making edge line around WCA a little more darker (black)

  • 19 février 2011 03:42 WashingtonCollectors
    Porteur du Projet

    KakoPouli: Make the white line a little thinner. Try this also; either make the last mt. on the right bigger, or add another mt. peak above the one on the far right. I would like to see the left part of the "W" extended a little higher into the map. Keep same concept that of the new created mt. peak, the white line comes down and starts to form the white part of inside line of the W. Also, how does the white line look like if the WCA was more solid green?

  • 19 février 2011 03:38 WashingtonCollectors
    Porteur du Projet

    room171: #136- good, but I think the WCA letters are a little too skinny and need to pop out more. Can you edge some drop shadow edge to the map to make it pop more? Please re-check my previous comment about the map peninsula area. Thank you.

  • 19 février 2011 03:25 WashingtonCollectors
    Porteur du Projet

    x3mart: #140 #141- Looks good. I am curious to see you play with the mountain element, work with it a bit and see if you can kind of make a half pyramid/half mountain shape, so maybe bring the bottom left/right tips in a little, and push the peak a tad more to the top, gives it even more of an upward thrust appeal...also give the map a little depth with a drop shadow type edge...can i see what you can do with connecting together the WCA letters, similar to what KakoPouli has done? Also, give me the same concept, but a different font style that might be a little more bold and suiting. Thanks...good work.

  • 18 février 2011 13:45 WashingtonCollectors
    Porteur du Projet

    KakoPouli: #123-looks too busy with words all over the place competing with each other...balance is off with elements. #124-not bad, would like to see this in a different font style. #125-try this...the last little mt. in the map, have it's white line continue down then go up into the W and continue going up/down all around through the middle of the letters in WCA. So basically you would be inserting a middle white line inside the middle of the WCA letters. You might have to make the WCA letters a little wider in order to get the effect. Thanks. #121-try softer black lines around WCA. Go for It's too black...try going 50% less black, more on the grey side. Maybe have the edge line around WCA is little more subtle so it looks better.

  • 18 février 2011 13:20 WashingtonCollectors
    Porteur du Projet

    FiddlinNita: I just have not seen any examples of that tree thing working in any other way..previous comments have addressed I need to see more trunk of the tree, perhaps make it smaller, how about some color in this example? font/text is a little boring and plain. Thank you working on this.

  • 18 février 2011 13:07 WashingtonCollectors
    Porteur du Projet

    babai: #131- it's too busy looking crammed with WCA and other stuff. The pedestal concept does not work. Thank you though.

  • 18 février 2011 12:51 WashingtonCollectors
    Porteur du Projet

    x3mart: #129 #128 #127- lets work with this concept. Keep map, make the mt. not as striking to stand out. I do like how it kind of like symbolizes polarizing both ends of the state, and comes together at a peak like a sense of achievement. Let's drop the artsy WCA you put together, keep the W where it is at, then give me simple CA to the right of it. Have WASHINGTON all spelled out centered underneath the map and WCA, the collectors association centered underneath that. #118- don't care too much for the logo in that. River element is not noticeable or serves a purpose. #110-WCA logo just not working, nor does the mt/river element. #108- i like the mountain element better.

  • 18 février 2011 12:41 WashingtonCollectors
    Porteur du Projet

    gtender: Hello. #109-Simple,nice to the point. Try collectors association a darker green. Clean up the map edges so those little islands are not showing in the puget sound area. What does this look like B&W?